Main technical characterestics and list of basic equipment

Table 1

Useful capacity, kWatts (hp)	452 (615)
Mode of working	See table 2
Assembly base
- chassis type	KrAZ-63221-0000044
- engine power, kWatts (hp)	240 (330)
- load capacity, kg	22725
Power unit
- diesel engine	V2-800TK-S4
- aggregate capacity, kWatts (hp), not more than	588 (800)
- rotation frequency of crankshaft, rev/min, not more than:
a) under the aggregate capacity	2000
b) maximum	2300
- starting system	electric starter ST 722
- accumulator, 4 items	6ST-190
Gear box
- type	3KPm
- gear ratio:
a) at I gear	4,67
b) at II gear	3,43
c) at III gear	2,43
d) at IV gear	1,93
Pump
- type	3PN-70S
- useful capacity, kWatts	452
- plungers, items	3
- plunger diameter, mm:
a) in delivered set	100
b) in spare set	120
- plunger stroke, mm	200
- gear ratio of power end	4,86
Rotary pump
- type	CNS 60-200
- shaft speed, rev/min	1475
- feed, m3/h	60
- maximum pressure, MPa (kgf/cm2)	2 (20)
- transmission	from chassis power takeoff
Measuring tank, m3	4
Manifold
- internal diameter of pipe line section, mm:
a) suction	100
b) discharge	50
Control of the unit	From chassis cabin
Auxiliary pipe line length, running meter, not more than:
- suction, 1 item	4
- discharge, 7 items	37 (total)
Auxiliary equipment
- cementing tank volume, m3	0,25
Total dimensions (L x B x H), mm, not more than:	11 000 x 3 910 x 2 780
Weight, kg, not more than:
a) of equipped unit: chassis, attached implements (including chassis complement , accessories set, etc.), spare wheels*, fuel, lubricant, cooling systems filling)	26 200
b) of attached implements unit	14 200
c) of equipped chassis	12 000

Table 2

Unit mode of working (rotation frequency of diesel crankshaft 1800 rev/ min)

Transmission	Total transmission ratio (gear-box-pump)	Number of double stroke of pump plunger, a min.	Plunger d=100 mm		Plunger d=120 mm
			Pressure, MPa	Feed, l/s	Pressure, MPa	Feed, l/s
I	22,60	80	70,0*	6,3	51,0*	9,0
II	16,55	109	54,0	8,5	37,5	12,3
III	11,80	153	38,0	12,0	26,6	17,3
IV	9,40	192	30,5	15,0	21,0	22,0

Notes
1 The value of FEED characteristic is calculated.
2 ATTENTION! After the first launching the rig should pass through 60-hours breaking-in. During the breaking-in the value of PRESSURE characteristic should not exceed 75 % of mentioned one. After the termination of the breaking-in you should discharge hot oil from the pump and gear-box, wash the oil reservoir and fill up with fresh oil.
3 * Overload capacity of discharge pressure in appropriate plunger diameter, at which the rig can operate for a short period of time.

The unit on-stream time at any regime is limited by the reheat temperature of oil in pump frame crankcase.